![]() 120-Volt AC 10,000 AIR Limited lifetime warranty Learn More About Circuit Breakers Here in our Buying Guide. Do not continue if power is present on a circuit breaker other than Service Disconnect or Main circuit breaker, until the power source has been shut off. Square D QO 15 Amp single-pole combination AFCI circuit breaker Compatible with Square D QO breaker boxes, CSED's and NQOD panel boards This breaker needs 1 space in a breaker box for installation. It is not safe to install a circuit breaker in an electrical panel that still has power flowing to it.Testing at the Service Disconnect or Main circuit breaker is not recommended due to this "seemingly conflicting" information. The ANSI-certified and UL-Listed unit is rated for 120/240 VAC and 10,000 AIR. This breaker is compatible with Homeline load centers and CSED devices. The bus bar should have no power present when this breaker is OFF. The Square D by Schneider Electric Homeline 15 Amp One-Pole Circuit Breaker is used for overload and short-circuit protection of your electrical system. HOM115AFIC breakers do not meet the current 2002 national electrical code requirements and should be used as replacement. Compatible with Square D Homeline breaker boxess and CSED devices with 1 space. Use for arc-fault, overload and short-circuit protection of your electrical system. The output of the Main or Service Disconnect when located in the panel, connects to the bus bar. Square D Homeline 15 Amp single-pole AFCI circuit breaker. If the Service Disconnect or Main circuit breaker is in this panel, it will always indicate power on the terminals that have cables connected.Make sure your test light is set to the highest AC voltage range available (and is set at minimum to 120 volts).If 120 (or more) volts is indicated, the panel is still being powered and will need to be turned off before proceeding. Touch 1 probe to ground (the bar that has bare or green and white wires connected) or neutral (the bar that has just white or just bare or green wires connected) and touch the other probe to the screw terminal of a circuit breaker that has a black, red, or blue insulated wire connected. ![]() Use a test light or meter set to check for the presence of power. ![]() ![]() Test the panel to make sure the power is off. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |